5 Replies Latest reply on Mar 9, 2016 2:36 AM by MichelleC_Intel

    How do I prevent the error "No source available for "0x...""?

    JDHolland

      I am using ISSM_2016.0.027 to program the D2000.  Once Eclipse starts up I push the reset button on the D2000 as well as reset OpenOCD.  I see "Info : JTAG tap: quark_d2000.lmt enabled"  in the OpenOCD session which I understand to mean the D2000 is ready to be flashed and debugged using the bug icon on the toolbar.  After flashing I often get the error "No source available for "0x31d"".  I have also seen "No source available for "(gdb[0].proc[42000].threadGroup[i1],gdb[0].proc[42000].OSthread[1]).thread[1].frame[0]"".

       

      How do I prevent this error from happening so that I can enter debug mode correctly?

      Related, when I successfully flash the D2000, enter debug mode, run through the program and then exit but want to then go back into debug mode without reflashing, I get the same "No source available..." error.

       

      Is there a series of steps that should be followed when trying to enter debug mode?