5 Replies Latest reply on Feb 12, 2016 4:24 AM by doppelganger

    DS2 and DS3 are light up when Expansion Board is turned on

    doppelganger

      Hello,

       

      I followed Get Started Guide:

           - installed edison. (here I did sloppy work first and didn't press it well, so afterwards "expected" LED(DS1) blinked once every time I turned on the board)

           - plugged 2 microUSB w/o DC power supply

       

      And now when I turn on the board I see that DS2 and DS3 are light up, while DS1 blinked once right after power.

      20160202_224729.jpg

      Also processor is getting hot(don't know what is expected temperature, probably it's OK)

       

      How bad is it ? Any advice?

       

      Thanks