14 Replies Latest reply on Jan 22, 2016 4:11 AM by muhamad.soffi

    Quark D1000 CRB v3 - Serial Console

    AdrianBurns

      Hi,

       

      Went through the full ISSM Installation Guide for D1000 step by step.

      Page 7 says the below about connecting at 19200 but i never see any output.

      This does not work at 19200, or at 115200. State1 and State 2 LED's flash alternately.

      I however, can find the jtag "tap" when i connect via openocd/ISSM and that works fine as per ISSM User and Reference manual.

       

      Also, the reset button on the CRB doesnt do anything, i presume it should reboot the D1000? and we should see boot messages in putty also?

      Do i need to hold the reset button for a certain number of seconds?

       

      thanks

       

      avijit.M bartosz.firmwave

      serial_console.jpg