1 2 Previous Next 23 Replies Latest reply on Jan 25, 2016 3:38 PM by HenryBeitz

    NUC6i5SYK BIOS recovery

    HenryBeitz

      After changing some BIOS settings my NUC would not boot. I downloaded both BIOS files SY0024.BIO and SY0028.BIO.

       

      The BIOS file SY0028.BIO was the only file on my USB memory stick.

      All USB peripherals, except the memory stick, were removed.

      The BIOS Security Jumper was removed.

      The following appeared on the monitor:

       

      Flashing image for Main Block firmware ... [done]

      Flashing image for Graphic firmware ... [done]

      Flashing image for FV Data firmware ... [done]

       

      Flash update has completed successfully.

       

      Recovery complete.

      Changes to BIOS require a full system reset.

      Power off the system and unplug the AC power cord.

      Restore the BIOS Security Jumper in Normal (1-2) or Lockdown (2-3) position.

      Then restore AC power and power on the system.

       

      I did all of this and also removed the USB memory stick. I use an HDMI to DVI cable for my monitor.

       

      The system does not boot and my monitor indicates that there is no video signal.

      Where do I go from here?

        1 2 Previous Next