4 Replies Latest reply on Jan 11, 2016 1:10 PM by RoboBill

    ROS on the Galileo Gen 2

    RoboBill

      I'm very much a beginner. I've got the sd card installed, logged on to the board and also uploaded the blink sketch via the Arduino IDE. I'm now interested in putting ROS (robot operating system) on my Galileo to control/drive a robot and read on-board sensors.


      Is it possible to install and run ROS on the galileo and if so where can I find the latest and hopefully simplest procedures/tutorials?

       

      Thanks

       

      RoboBill