0 Replies Latest reply on Jan 5, 2016 5:05 AM by MichelleC_Intel

    Intel® Quark™ Microcontroller D2000 - Debug/Run Project (Flashing) Fails: ‘Error message from debugger back end: Load Failed’

    MichelleC_Intel

       

      ISSM is unable to connect OpenOCD to the JTAG interface.

       

      Disconnect/Re-Connect the Micro USB Cable on the Board and try again.

       

      If there is still an issue verify ‘OpenOCD JTAG’ is connected via Device Manager.

       

       

      If necessary re-install the driver using the install.bat located in C:\IntelSWTools\ISSM_2016.0.0XX\tools\debugger\driver