Which expansion board are you using?
If you are using the Arduino Expansion board, take a look at: Intel® Edison kit for Arduino – Buttons and Switch
If you are using the Breakout Board; try running configure_edison --enableOneTimeSetup
You can find more information in here: IoT - Getting started with Access Point (AP) Mode for the Intel® Edison board | Intel® Developer Zone
I'm using the Breakout Board. Is it possible to go into AP Mode without terminal access using the Breakout Board? Reason I'm asking: AP Mode doesn't seem very helpful if you need terminal access to enable AP Mode. Chicke/egg sorta thing.
This is Pradeep and I was working with Intel edison Board. After switching AP mode I am facing some problems in turning my Edison board as Hotspot. I made my Intel board as Hotspot but I can not able to get any data to access. Could you please help me out with this issue ....