6 Replies Latest reply on Nov 19, 2015 2:20 PM by PrescottJoule

    How to use mini breakout board with 3.3v and 5v logic boards

    PrescottJoule

      I am planning on using the Edison with GPS and 9DoF boards (http://www.adafruit.com/product/1714 and http://www.adafruit.com/product/746).

      Both work simultaneously on an Arduino Uno or as one uses pins 4&5 and the other uses TX & RX. The problem is I would like to use them with the mini breakout board which uses 1.8v logic. Not 3.3v or 5v like the GPS and 9DoF do.

      My question is how can I use the Edison's 1.8v logic provided by the mini breakout with the 3.3v and 5v logic accepted by the GPS and 9DoF boards. Is it possible (and if so how) or should I just use the Arduino expansion board.

      Either way any advice is appreciated.