1 Reply Latest reply on Dec 8, 2009 3:45 PM by vkolli

    WHS on SS4200-E - Power LED flashing blue

      I installed WHS on SS4200-E by removing DoM and with one new hard disk.  I used the slipstream procedure that did not require any new hardware.  Before I had the system running EMC software and with 2 HDs.  I replaced these disks with one new disk for WHS install.   System seems to be functionining OK except for power LED keeps flashing blue.  WHS is also indicating disks and network status to be good.


      Is it normal when running the system without DoM?  What happens when I put the DoM back in?  It still should boot from the disk, right?  how do I take care of flashing power LED.