2 Replies Latest reply on Dec 5, 2009 12:15 PM by rustyb422000

    dg43gt POST single beep

    rustyb422000

      Just installed a dg43gt.  On POST, there is one beep, then the ME starts up, followed by a single beep.  In technical documentation, it says you might get one beep following a recoverable error during POST, but the only single beeps listed are "POST complete" and "processor intialization complete".  These sound more like status messages than errors.

       

      After booting, the system appears fine.  No other error messages are displayed as the bios does its thing.

       

      Is there a problem with this board or is this normal behavior?  If it is normal, is there any way to disable the annoying beeps?  If an error, any suggestions on what it is?

       

      Thanks,

       

      Rusty