1 Reply Latest reply on Dec 1, 2009 11:28 AM by back2rota

    Server 2008 failure with SE7210TP1-E Sys Bd

    back2rota

      Greetings Everyone,  I'm using an SE7210TP1-E Entry level server board with 3.4ghz P4 and 4gb of ram but when I try to clean install Server 08 it doesn't recognize the two SATA drive installed.  States I have to load drivers for them.    I used the system bd CD but 08 indicates no device driver found.   I'm new at this and hope someone can point me in the right direction.

        • 1. Re: Server 2008 failure with SE7210TP1-E Sys Bd
          back2rota

          Turns out I was able to answer my own question.    After updating the Bios to v.10 I now had the ability to change SATA settings under the IDE setting.   You need to change from SATA Raid to "Map PATA to legacy ATA and Config SATA".   Once you make that change Server 2008 will recognize your SATA drives and you can start the install process.