1 2 Previous Next 25 Replies Latest reply on Dec 11, 2015 6:27 AM by DavidGS

    i2c sensor not detected (MLX90614)


      I'm using the IR Temperature Sensor from Adafruit (MLX90614) :


      Wiring and Test | Using Melexis MLX90614 Non-Contact Sensors | Adafruit Learning System


      Which I connected to the i2c breakout from sparkfun:


      SparkFun Blocks for Intel® Edison - I2C Breakout Block - learn.sparkfun.com


      However, when running: i2cdetect -y -r 1 I see no devices. I tried with another i2c device. This address is shown. I attached the temperature sensor using the same hardware setup to an Arduino and there the device is also recognized. Any ideas on how to use the sensor on the edison? In my belief, if one i2c device works all should work, I wonder if it can possibly be some kind of compatibility issue? Any ideas on how to get this sensor to work?

        1 2 Previous Next