10 Replies Latest reply on Sep 9, 2015 7:36 PM by webster342

    Edison otg USB fails to establish connection to PC on Arduino and Mini breakoutboards

    laniko

      I tired the Intel Edison on both the Arduino Board and the Mini Breakout board on my desktop and laptop USB ports.

       

      Both my computers detect the Edison for second then disconnect and reconnect and disconnec and so forth as long as usb connected to the edison.  Last week i was able to flash firmware on it but now it is not establishing a long enough connection to do anything at all.

       

      I have tried all possible combination and confident this is some COMM connection issue caused by the Edison Chip.

       

      Without getting a reliable connection I am unable to even run the flash tool.

       

      Anyone from Intel have any suggestions? Def disappointing at the quality as this chip is not cheap and I have had it for barely over 3 months.