2 Replies Latest reply on Aug 28, 2015 10:09 PM by lpalacio

    Edison won't boot past GADGET DRIVER: usb_dnl_dfu

    lpalacio

      I have an Edison connected to the Arduino board using the dual micro-USB cables and the switch is toggled correctly, the board was working fine until I started working on a new laptop, I started installing iotdk_win_installer.exe and didn't notice i had the board connected, apparently part of the process is to flash the boards which it did and then the board rebooted by itself. After that the board won't boot to the login prompt, but instead gets stuck at the line listed below:

       

       

      ******************************

      PSH KERNEL VERSION: b0182b2b

                      WR: 20104000

      ******************************

       

       

      SCU IPC: 0x800000d0  0xfffce92c

       

       

      PSH miaHOB version: TNG.B0.VVBD.0000000c

       

       

      microkernel built 11:24:08 Feb  5 2015

       

       

      ******* PSH loader *******

      PCM page cache size = 192 KB

      Cache Constraint = 0 Pages

      Arming IPC driver ..

      Adding page store pool ..

      PagestoreAddr(IMR Start Address) = 0x04899000

      pageStoreSize(IMR Size)          = 0x00080000

       

       

      *** Ready to receive application ***

       

       

       

       

      U-Boot 2014.04 (Jun 19 2015 - 12:05:55)

       

       

             Watchdog enabled

      DRAM:  980.6 MiB

      MMC:   tangier_sdhci: 0

      In:    serial

      Out:   serial

      Err:   serial

      Hit any key to stop autoboot:  0

      Target:ifwi

      Partitioning already done...

      Partitioning already done...

      Saving Environment to MMC...

      Writing to MMC(0)... done

      GADGET DRIVER: usb_dnl_dfu

       

       

      I can however interrupt the boot process which leaves me in a boot prompt but i'm not sure where to proceed from there

       

      ******************************

      PSH KERNEL VERSION: b0182b2b

                      WR: 20104000

      ******************************

       

       

      SCU IPC: 0x800000d0  0xfffce92c

       

       

      PSH miaHOB version: TNG.B0.VVBD.0000000c

       

       

      microkernel built 11:24:08 Feb  5 2015

       

       

      ******* PSH loader *******

      PCM page cache size = 192 KB

      Cache Constraint = 0 Pages

      Arming IPC driver ..

      Adding page store pool ..

      PagestoreAddr(IMR Start Address) = 0x04899000

      pageStoreSize(IMR Size)          = 0x00080000

       

       

      *** Ready to receive application ***

       

       

       

       

      U-Boot 2014.04 (Jun 19 2015 - 12:05:55)

       

       

             Watchdog enabled

      DRAM:  980.6 MiB

      MMC:   tangier_sdhci: 0

      In:    serial

      Out:   serial

      Err:   serial

      Hit any key to stop autoboot:  0

      boot >