2 Replies Latest reply on Oct 8, 2015 11:38 PM by hexuyangguang

    Eclipse IDE cannot search target

    Euphrate

      I just started using Intel Edison Breakout Board for personal project, and I've been following the procedure as described in loT website. However, I've encountered a problem when I was trying to establish connection from my Edison to Eclipse. The picture below is where I have problem (IoT - Blinking an LED with the Eclipse* IDE on the Intel® Edison board | Intel® Developer Zone this is the link to the page)

      Screen Shot 2015-08-16 at 10.10.02 PM.png

      When I try to search my Edison, it doesn't show up in my target connection. I've flashed my board, and I've established a wifi connection too. Any helps would be appreciated, as I'm new to this entire process. Thanks!