2 Replies Latest reply on Jul 28, 2015 10:57 AM by msuwelle

    "Unrecognized filesystem" and "panic notified" - Edison not starting

    msuwelle

      Hey,

      my Intel Edison still does not show up in Windows Explorer (see Intel Edison not found), but now I have been able to form a serial connection to the device. I now discovered that the Edison keeps rebooting and shows some errors all the time.

       

      [    2.144364] Call Trace:

      [    2.144418]  [<c18d9eea>] dump_stack+0x16/0x18

      [    2.144473]  [<c18d7de4>] panic+0x81/0x178

      [    2.144527]  [<c18cb024>] kernel_init+0x154/0x160

      [    2.144582]  [<c18e4bf7>] ret_from_kernel_thread+0x1b/0x28

      [    2.144640]  [<c18caed0>] ? rest_init+0x80/0x80

      [    2.144755] emmc_ipanic: panic notified

      [    2.144794] emmc_ipanic: Crash partition in use!


      It always ends with the message


      *** Ready to receive application ***


      , but I am not able to type in anything. After a short time, the Edison reboots.

      So I wanted to update the firmware via serial connection, because I suspected an error in the firmware, but when I pressed a key to stop autoboot and typed in the command "run do_ota", it showed

       

      ** Unrecognized filesystem type **

      Saving Environment to MMC...

      Writing to MMC(0)... done

      resetting ...

       

      but did not update/reset/reflash anything. Same with the command "run do_flash" (except there wasn't the message about the unrecognized filesystem type).

      I hope, anyone of you can tell me what to do to finally use my Edison...