6 Replies Latest reply on Jun 26, 2015 3:35 PM by Intel_Alvarado

    Reset wont work on Galileo Gen1

    noris

      hello, i'm using Galileo Gen 1 with Linux on SD card.

      i uploaded a simple sketch :

       

      int led=0;

      void setup()

      {

         pinMode(led,OUTPUT);

         digitalWrite(led,HIGH);

         deley(5000);

      }

       

      void loop()

      {

        digitalWrite(led,HIGH);

        deley(1000);

        digitalWrite(led,LOW);

        deley(1000);     

      }

       

      the led is turn on and after 5 sec it's start to blink, when the board is connected to the PC , i press the reset button and it work fine

      however when i unplugged the cable , the sketch run but the reset button wont work, i need to take out the power and plug it back to reset the system.

      there is any way to make the resert button work?