1 Reply Latest reply on Jun 11, 2015 7:28 AM by waaraawa

    Fail ScanNetworks with Intel centrino 6235

    waaraawa

      Hello

       

      My wifi card is intel centrino 6235(https://wireless.wiki.kernel.org/_media/en/users/drivers/iwlwifi-6000g2b-ucode-18.168.6.1.tgz).

      and I made auto connection successfully as below.

      But I'm trying to do "ScanNetworks" example with Arduino IDE 1.6.0 but "WiFi shield not present" is shown.

      WiFi.status() return WL_NO_SHELD.

       

      root@galileo:~# ifconfig
      ~~~~~~~~~~~
      
      wlp1s0    Link encap:Ethernet  HWaddr BL:IN:DE:DD:DD:DD 
                inet addr:192.168.0.17  Bcast:192.168.0.255  Mask:255.255.255.0
                UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
                RX packets:832 errors:0 dropped:0 overruns:0 frame:0
                TX packets:54 errors:0 dropped:0 overruns:0 carrier:0
                collisions:0 txqueuelen:1000
                RX bytes:57500 (56.1 KiB)  TX bytes:11487 (11.2 KiB)
      
      root@galileo:~# iwconfig
      lo        no wireless extensions.
      
      wlp1s0    IEEE 802.11abgn  ESSID:"MyWiFi" 
                Mode:Managed  Frequency:5.2 GHz  Access Point: BL:IN:DE:DD:DD:DD 
                Bit Rate=52 Mb/s   Tx-Power=15 dBm  
                Retry  long limit:7   RTS thr:off   Fragment thr:off
                Encryption key:off
                Power Management:off
                Link Quality=56/70  Signal level=-54 dBm 
                Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
                Tx excessive retries:0  Invalid misc:41   Missed beacon:0
      
      enp0s20f6  no wireless extensions.