Let's try without the check in "Use ssh keys". Is your IP: 192.168.2.15?
If you are not very sure about this, run the following line:
root@edison:~# ip address |grep wlan0
you will get something like this as outcome:
wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast qlen 1000
inet 192.168.1.1/24 scope global wlan0
After this try again to fill the spaces with the IP address of your board:
User Name: root
Did you update the daemon by clicking the buttom?
And, what is the outcome after the last image? The one where you put the address:10.1.1.56, Port: 58888, User name: root, Password: PasswordOfTheBoard
Also, what is the outcome of running:
root@edison:~# configure_edison --version
Which image are you using in your board? If you are not sure of which one are you using, you can run the command configure_edison --version, I think the command you ran was configure_edison --setup and not the --version. If the version is other than 159, you can download the latest version from: Intel® Edison Board Download