6 Replies Latest reply on Jun 17, 2015 9:35 PM by wb_Intel Branched to a new discussion.

    ESXi 6 X710 Port Speed configuration

    Steffen_ST

      I have several X710-DA2 cards in the ESXi Server. When I leave the port speed of that cars as it is everything works fine. When I try to change the speed to 10GBit I get an error message: "Forcing 1000Mbps or faster may not be supported on this network device, please use auto-negotiation instead"

       

      After that all X710 ports go offline and I cannot be activated again. The link is down and the vmnic has a red cross.

      The only way to get it working again is to Restore the ESXi configuration backup that was made before the change.

       

      Driver/Firmware is the following:

      [root@localhost:~] ethtool -i vmnic4

      driver: i40e

      version: 1.2.48

      firmware-version: f4.22.27454 a1.2 n4.25 e143f

      bus-info: 0000:0d:00.0

       

      Any ideas?

       

      Regards,

      Steffen