Are you able to see the Serial cable when you connect it to the PC?
You entered "But I don't see any start up messages." Are you able to use the board and get into the Terminal Console or do you mean that you are not able to look anything on your PC?
Yes, I do see a COM port corresponding to the serial cable. Since I'm also using ssh
to log into Galileo, I know the system is up and running. I opened putty using the COM
port corresponding to the serial cable (and baud rate of 115200 as recommended). But
I don't see anything in the terminal (such as prompt) ... So I went checking with a volt
meter :-) ...
1 of 1 people found this helpful
Hi raoloka ;
One thing you could do is to check the signals in the FT232RL, the signals must be 3.3V in order to be fully recognized for the board.