4 Replies Latest reply on May 1, 2015 10:57 AM by aneedles

    Reset of Intel Edison is required to load a new or updated application from Eclipse...

    aneedles

       

      I am using Eclipse and C/C++ to develop for the Intel Edison. I can successfully download and run an application over the virtual Ethernet over USB, but there appears to be no way to reset the Edison to accept a modified application without doing a full power reset. The Eclipse IDE does not have any obvious way to stop and clear the remote application - as I am used to seeing in other embedded debugging tools. This would be much easier than frequent power resets of the Edison target. Is there a way to do this from Eclipse? Or a  way to do a soft reset without unplugging and re-plugging the Edision?

      Thanks,

            Aaron