9 Replies Latest reply on Feb 24, 2015 4:32 PM by polares

    When I upload the project into the edison+arduino, it get stucks

    polares

      Hi, I'm new to Edison + Arduino. In fact it's my first time that I interact with this.. I followed all the steps given in Intel Edison Support to setup my board and start a basic project. My issue is that I cannot upload the project into the Edison + Arduino board. It's get stuck.

       

      I started with the Basic project Blink. Next is the picture that shows where, when I upload the project into the edison+arduino, gets stuck

       

      Arduino.png

       

      By the way. The board is Intel Edison (the only one that I have) and the Com is 3

       

       

      All the software was downloaded today from Intel Edison Support. so I think is up to date

       

       

      Please your help to solve this. I would like to move forward :-)

       

       

      Thanks in advance.

       

      Regards,