3 Replies Latest reply on Feb 23, 2015 1:43 AM by SAHER_MAQSOOD

    GPIO Mapping for G2 board

    SAHER_MAQSOOD

      Hello,

      I am working on the yocto linux image.

      I want to blink an led on the pin marked as 8 (Digital PWM) on galileo board G2. I am using the code given in section 5 of the following link:

       

      IntelGalileo/IntelGalileoGPIO - ROS Wiki

       

      In the code i replace line 8

        pin1export.write("3")

      with

        pin1export.write("8").


      The code compiles and runs,displaying on and off statements but the led is not blinking. what can i do to debug it?

      If i blink the led using arduino ide blink example, it works.(i use led 8 in the blink example) 


      Regards
      Saher Maqsood