13 Replies Latest reply on Feb 9, 2015 1:27 PM by CMata_Intel

    New to Galileo.  Boots, but sketches do not run, and I am unable to update firmware.

    redruM69

      Recently picked up a 1st gen Galileo.  UART console works fine, and I can see that it boots up OK either from SPI, or from an SD card.  Arduino IDE will successfully upload the sketch, but it just doesn't run.  Also, when I attempt to upgrade the firmware to 1.0.4, it fails and bricks the Galileo.  I am forced to do a firmware recovery to get it back to a booting state.

       

      Where should I start?

       

      Thanks!