2 Replies Latest reply on Dec 17, 2014 4:25 AM by Krolo

    New board dead?

    Krolo

      I just got my Edision board and groove kit today. I had it all working and was mainly playing around with the rgb LCD display and noticed that code was still showing up from previous sketches. It helped a few times to reset the board before I uploaded new sketches but then the arduino part just seemed to have died. I still have yacto linux console access. I still can upload the code without errors but nothing happens, not even the simple blink sketch. Are there any commands I can shoot at this to see if I can get it to come back to life? I may have just got a bad board somehow..