You mean you connect the same camera when the module on the Arduino expansion board - and it's okay, then you flip the same module and the same camera over to the mini-breakout board and there it reboots/crashes?
What specific messages are you getting on crash (console log or something would be the most useful)? How do you power the board in both cases?
1 of 1 people found this helpful
mweal I have not connected a webcam to my Edison project yet. However, digging into the depths of the forum I found https://communities.intel.com/message/255454#255454 and I wondered if it might shed some light on your issue.
Doh! I tried it again, and after a few days of not working, it works now. I was powering from J21 with 5V, so I guess the voltage was marginally low.
Yep, that was something I suspected. Glad to hear it works fine now