2 Replies Latest reply on Nov 3, 2014 10:51 AM by DiegoV_Intel

    A problem about otg hub

    wumf

      hello everyone,

          

             Is it wrong to otg connect usb hub ? My edison's otg connect usb hub , and I want to flash edsion by usb ,but it is unsuccessful.

        • 1. Re: A problem about otg hub
          rosenrot

          I do not know if I got you right, but you need to connect the centered USB connector directly to your computer. A new volume should appear and then you have to copy the new image onto it.

          • 2. Re: A problem about otg hub
            DiegoV_Intel

            Hi,

             

            You should select the correct USB port (device mode) on the Arduino Expansion Board. Use the tiny switch to select the USB port. See the picture below, I marked what is the USB port you should select and the correct position of the switch. Let us know if this worked.

             

            Device USB.jpg

             

            Regards,

            Diego.