2 Replies Latest reply on Jan 27, 2015 2:49 PM by Intel_Alvarado

    Problems with pins 1,2,3 INTEL GALILEO 1

    Jbustamante90

      Hi.

       

      I have problems with my Intel galileo 1.

       

      When i conect my galileo to source, while the boot is runing, pins 1,2 and 3 stay in HIGH state with 5 volts.

       

      That causes a few problems because in those pins i have connected a solenoid valvles, and while the boot program from galileo is running cause an activation in these pins and activate my solenoid valves connected with a transistor switc.

       

      After boot programs is ready, the board run my program loaded normally, but i don't need that pins activated when my program isn't working yet.

       

      Thanks a lot for any quick answer.

       

      Best regards.