7 Replies Latest reply on Nov 27, 2014 11:27 PM by golzio

    Intel NUC DN2820FYKH can't access BIOS

    gianpaoloracca

      Hi,

      I jyst purchased the NUC in the object line, but I can't access the BIOS. I updated (I think, the power light was blinking and I waited 5 mins.) the BIOS to the latest version using the recovery procedure (jumper + usb stick), since I couldn't get any video signal showing up on my TV connected via HDMI cable.

      After the update, and after having put the jumper back, I get the message "No boot USB device or something like that which is fine.

      I tried to use a Win7 usb-key install, but the installer starts and then crashes due to hardware compatibility (I suspect ACPI related).

      So I wanted to tweak some BIOS settings to let windows installer run smoothly but I can't access the BIOS.

      If I press f2 at boot the screen just stays black. I read about the 1024x768 requirement but I think that either my TV (Panasonic TH-37PX80E) either my AVR (Yamaha rx-v775) support this resolution.

      The keyboard I think it's working since I can start and finish the linux installation process (OpenElec) from a USB key.

       

      Any advice for me?

      Thanks,

       

               Gianpaolo