2 Replies Latest reply on Oct 31, 2014 5:37 PM by Intel_Alvarado

    Edison USB Host mode

    broody

      Hi,

       

      I was wondering for the mini-breakout board is there anything special we need to do before using it in USB Host mode with an OTG cable? The reason I ask is because on the Arduino version there's a little switch that you toggle to do this.

       

      In section 2.2 of edison-breakout_HG_331190.pdf it says "Edison is designed to support OTG, using the ID signal" and I was wondering where this signal is... I'm still trying to figure out how I fried my board by plugging in a webcam...

       

      Thanks.