5 Replies Latest reply on Oct 7, 2014 6:48 AM by allan_intel

    RAID 1 failure of both drives - cant rebuild spare


      I have a system that is/was configured and running with a RAID 1 (mirrored) boot drive with a spare drive


      When I turn on the computer today, the entire disk system seems to have failed. It asked be if I wanted to rebuild using the spare (I said YES) and was informed that the rebuild would occur in the operating system. Sadly, the operating system won't boot (both RAID1 drives are shown as failed) - I had powered off and disconnected one drive (Port:2) in an attempt to ensure no further "damage" was done..

      Now the config shows the following..




      Any suggestions, help, or advice?

      These drive have been working well since they were installed, I cannot imagine both failing at the same time!