7 Replies Latest reply on Jun 6, 2016 1:57 AM by phyllisctabor

    Design for a 3D printed Edison Case


      I'm designing a 3D printable Edison Case.  The 3D model is done, and I've done some preliminary prints.  This version is printing right now: if all goes well, I should be able to post real photos.

      This was printed on an Atom based 3D printer (but not, however, edison based....yet).

      Some of the salient features:

      Slots for Arduino, plus all side accessible receptacles (USBx3, power, usb switch, uSD.

      Light pipes for DS1-3.

      Switch access for 5 on-board switches.


      I'll post stl once the design is reasonably correct.