11 Replies Latest reply on Mar 6, 2015 10:03 AM by Furuvio

    D54250WYKH - mSATA + SATA issues

    mortimermarker

      Apologies if this has been discussed before.

       

      Intel NUC KIT D54250WYKH with mSATA and SATA drives installed [Samsung 840 SSD (6Gbps) mSATA and Seagate ST1000LM014-1E SSHD HDD (6Gbps)] and using USB flash drive for CentOS 6.5 minimal install.

       

      Boot/OS install problems:

       

      1) Legacy boot detection always identifies SATA port (not mSATA) as primary drive (/dev/sda) despite changing priority setting in Legacy boot order - identification is always mSATA port device 1, SATA port device 0

       

      2) UEFI detects no boot devices (typically nothing visible in UEFI BIOS boot order except UEFI Shell/PXE over IPv4/IPv6, though SSD/HDDs detected under SATA devices) of three available local drive options (mSATA SSD, SATA SSHD, USB flash drive)

       

      Any thoughts greatly appreciated

       

      Cheers