if my galileo booting from sd card , i connect galileo with my computer but it can't find the board,can't find com.what should i do?
Can you connect a 3.5 to rs232 and rs232 to USB cable or similar from the UART port to your computer and open a Putty session. This will allow us to see more in detail what Galileo is doing.
Also, what SD image are you using?
I used this. I don't have 3.5 to rs232,but I can try to make it.
and I am Chinese .so my English is so bad. Sorry.
Take a look at Sergeys blog he has detailed instructions on how to put one together.
i had made it,and then it shows like that:
but it works well without SD card.
Have you updated the firmware via the IDE? Can you include a screenshot of the content in your SD card? What size is your card? Is it formatted as FAT32?
Your SD content looks correct. Can you confirm you have updated the firmware successfully to 1.0.0 via the IDE?
yes, i have do it successfully twice today.
but there always have an error
without SD card it :
with SD card it :
and it didn't do anything after this:
thanks a lot
Retrieving data ...