3 Replies Latest reply on Feb 26, 2014 8:28 AM by kevin_intel

    How do I check SMART status on IRST RAID 5?




      I'm running Windows 7 64-bit and using IRST to build a RAID 5 out of five 2TB disks.


      At least one disk is bad, but IRST reports them as fine. Every few times I boot up IRST "verifies and repairs" the RAID array. This takes about 24 hours.


      I would like to check the SMART status of each disk to see if there is one that is going bad so I can replace it.


      I tried to use HD Tune, but it can't see the individual disks. It only sees the array.


      How do I see the SMART status for each disk in an IRST RAID 5 array?