I have the Power button Bug and want to remove the Batterie Cable to reset Bios, but i can´t remove the Mainboard.
There are two black Screws i took out, is that enough? Cant´t take out the board and i pulled strong enough.
What am I doing wrong?
Hello Aquila, it is not necessary to remove the battery cable to clear the CMOS of your NUC.
Please follow the instructions below
i tried it already, but when i set the jumper to 2-3 i have only a black screen, there is no setup mode, therefore i wanted to remove the Battery and hope, that my Powerbutton works again.
I have the same problem, did to solve it?
Retrieving data ...