1 Reply Latest reply on Feb 6, 2014 11:53 AM by Clayton Hofrock

    Serial.print no longer works

    Bosko

      I have sketches that used to work fine and now they don't.  Even serial.print doesn't work so I can't troubleshoot it.  Everything uploads properly and I get the "transfer complete" message, but serial monitoring shows nothing.  I have tried the following: a different computer, reinstalled the firmware, powering down the galileo.  I have also tried resetting the galileo and rebooting.  Any help would be appreciated it.

        • 1. Re: Serial.print no longer works
          Clayton Hofrock

          Sometimes, I have seen that the Arduino IDE claims that the sketch was uploaded, but it never did upload the sketch.

           

          To verify if this is happening, I upload the blink sketch. It is one sketch where you can see if it is running just by looking at the board. (there is a small LED that should blink). I would suggest trying that.