Now, I'm getting 0x01 from display code and dark screen.
I have since last Friday, a Intel Board "DZ87KLT-75K". I have problems with BIOS settings. When booting, the function F2 (BIOS settings) can not be called. I have the latest BIOS version "KL0446.BIO".I've assumed that I still can trim some of the settings to tune my system. Especially the Power Functions! Nothing goes in the direction and I've scoured the internet desperate for solutions.
"F7" goes "F10" But do not go "F2". Almost the most important function.
I went to store to replace my old DZ87KLT-75K for a new one. I've made a test again. When I uncheck the legacy boot priority the motherboard does not show bios anymore. I can't change anything and whorse, my pc does not boot anymore.
I'm very disappointed with Intel. One solution is a full hardware reset (Clear CMOS), but I'm trying do it without success. I removed the battery for an one hours still continued..
I don't know more what I have to do.
1 of 1 people found this helpful
Did you read the manual? There is a small button on the backside of the board called b2b (back2bios).
Plugin AC, push b2b button and power on the system.
This should bring you right to the BIOS.
I read the manual, but it did not work to me. I leave my board 4 hours without a battery, then worked.
I don't recommend disable "Legacy boot priority", I got a lot of problem because that.
I have founded something. Over HDMI is Visual BIOS not able to run. That's why after pressing "F2" the screen is blank. Also put on graphics adapter pure and monitor. Yeah, it's running! But once I connect the USB CDROM and reboot (changed the settings for IDE devices), no picture again. After that I reset BIOS made graphics adapter out / back into board! No reaction and nothing more to see. No chance to get back onto a stable level of config. Every time I change something (what some minor changes) shows an other behavior. Over night I have taken out the CMOS battery and will see tonight what then is going on. For me, the board or the software is not completely finished!!
Did you test BIOS recovery? It might work to get BIOS back to defaults:
Instructions for BIOS recovery available below:
What do you mean by "Over HDMI is Visual BIOS not able to run"?
I use a nvidia 560Ti for video output(via DVI port), but cannot enter the visual bios after upgrading bios to 0446, leaves me a blank screen at end.