1 Reply Latest reply on Jun 29, 2009 1:18 PM by Aryan2411

    Port assign information of RAID 10 on D975XBX2

    Sonny

      Reposted for: cwgsid2

       

      When I configure RAID 10 using 4 hard disks on D975XBX2 board I can't select drives for RAID 1 and RAID 0 volumes.

      I'd like to know how these ports are assigned for RAID 1 and RAID 0 volume.

        • 1. Re: Port assign information of RAID 10 on D975XBX2
          Aryan2411

          Hello,

           

          Firstly, let me summarize things on the board.

          It has 4 black SATA ports (Intel Matrix Controller), 3 Blue SATA Port (Marvell Controller), 1 eSATA (Marvell).

           

          Since RAID 10 needs to have 4 disks, i assume that you are using the Intel Matrix Controller (Ctrl+I), as it is not possible to create a RAID 10 on the Marvell Controller because only 3 sata drives can be connected to the blue SATA ports.

           

          Now with 4 non-raid disks:

          - you should be able to create raid0 on 2,3,4 disks, raid 1 on 2 disks, raid 5 on 3, 4 disks, raid 10 on 4 disks.

          - you cannot have a raid 10 and then another raid volume as well.

          - i never tried partitioning raid volume.

           

          Note: the marvell controller Ctrl+M and the Intel Matrix Controller Ctrl+I are two independent Onboard RAID Controllers.

           

          I have attached some pictures of the Intel Raid Bios for you as a reference.

           

          All the best,

           

          Regards,

          Aryan

           

          raid0.png

           

          raid1.png

           

          raid5.png

           

          raid10.png