2 Replies Latest reply on Jul 21, 2013 9:56 PM by edwardzh

    Can't enable jumbo frames


      I am trying to enable Jumbo frames on the switches in my MFSYS25 Intel Modular Server.  Every time I reset the switches to enable Jumbo Frames (after saving the configuration) the switch comes back up with Jumbo Frames disabled.  I have followed the directions on this Intel support document: http://www.intel.com/support/motherboards/server/sb/CS-031720.htm.


      This has not worked on either switch.  I have also pulled the switch module out of the chassis to allow it to reset.  This also did not work.  Any suggestions?