2 Replies Latest reply on May 4, 2009 9:42 AM by Aryan2411

    intel DG45ID Hardware Monitor  N/A Value

    rajeshonlines

      I am using DG45ID Mother board.  Im facing a problem in my board...

      1. In bios there is an option "Hardware Monitor". in this Option it displays all Mother board Parameters but all values are marked as 'N/A'...

           How can i Correct it...

      2. I canot Install IDT Audio Codec.... getting Error...

       

      Please help me... any defect in my Board..z?

        • 1. Re: intel DG45ID Hardware Monitor  N/A Value
          Aryan2411

          Hi Rajesh,

           

          To be honest, i remember to have one of this problem on one of my Intel Server Board, fortunately it was fixed when i tried this.

           

          Before doing these steps, do a cmos clear of the board by removing the battery & AC power and wait for 5 mins.

           

          1. Then try a bios recovery using a formatted USB media or Blank CD Rom.

          Instructions for Recovery BIOS Updates
          In the unlikely event that a BIOS update is interrupted, it is possible the BIOS may be left in an unusable state. The recovery process requires the chassis to be opened to move the onboard BIOS Configuration Jumper.


          WARNING: This process is intended to be performed by a trained technician.

           

          Recovery with Formatted USB Stick

          1. Copy the recovery file (*.bio) to a formatted usb disk/CR Rom.


             Website: http://downloadcenter.intel.com/T8Clearance.aspx?sType=&agr=Y&ProductID=2931&DwnldID=17583&url=/17583/eng/ID0095.BIO&PrdMap=&strOSs=38&OSFullName=OSIndependent&lang=eng

           

          2. Place the usb disk in the target system.
          3. Shut down the system and unplug AC power.
          4. Open the chassis and remove the BIOS Configuration Jumper. See the Technical Product Specification for details including the location of this jumper.
          5. Power the system on.
          6. Wait 2-5 minutes for the update to complete. When the usb drive LED is lit, the system is copying the recovery code into the FLASH device.
          7. System will either turn off when the recovery process is completed or it will prompt you to turn off the system.
          8. Remove usb disk
          9. Replace the BIOS Configuration Jumper.
          10. Restart system.

           

          Note: these can be found on:
          Website: http://downloadmirror.intel.com/17377/eng/BIOS%20Update%20Readme.pdf
          Page 3

           

          The latest bios is Version 0095.

           

          Let me know how it goes.

           

          Kind Regards,
          Aryan

          • 2. Re: intel DG45ID Hardware Monitor  N/A Value
            Aryan2411

            Hi Rajesh,

             

            I think i got the answer for the Intel Desktop Board DG45ID.

             

            The board has an option called Intel Management Engine Bios.
            You can access the MEBx bios by pressing Ctrl+P.
            Some board needs to have the settings enabled in the Bios in order to access it.


            Bios >> Boot Configuration >> Intel ME Setup Prompt: Enable.

            Go into the Ctrl + P MEBx Bios
            Intel ME COnfiguration >> Enter
            Intel Quiet System Technology >> Enable.
            Save and Exit

             

            It must work hopefully. :-)

             

            Kind Regards,
            Aryan.