Hi Dan Thanks for the reply
We are using seagate disks ST9600205SS
Based on the compat guide you send we need "minimum chassis fw level" UFU 6.8
How can I determine the Chassis FW level ?
Also on December 11 a note was added
MFSYS25 chassis must be with I/O fan module D91260-004 or higher and with power supplies D73299-008 or higher. See comments 7 and 8 for (I checked the power suplies and they are D73299-008)
(How can I determine the I/O fan module ?)
->>> In diagout out I see this
System Fan #1:
DID Structure Version #0x00
DID Structure Length: 94
DID Manufacture #0x00 Intel Corporation
Device identifier code 0x0033 Chassis Fan Control Module
Manufacture date/time (0x4e3906ac) Wed Aug 3 10:28:28 2011
Device name: Fan Control Board
Device part number: D70745-404
Is this for the I/O fan module we are talking about ? Do we need to replace with newer ones ?
(7) Chassis with TA#91400-006 or greater, come with new I/O fan module D91260-004 or higher. Chassis with old I/O fan module must replace with new I/O fan module. The TA number for the I/O Fan does not show in the GUI. The label on the bottom of the I/O module should be D91260-004 or higher.
(8) Chassis with TA#D91400-013 or greater, come with new power supply D73299-008, and chassis with old
power supplies must replace with newer power supplies D73299-008
1. To check you CMM FW version, login to the GUI and go to the Firmware page. It should tell you the current and previous version.
2. D91260-00x is the part number of the entire module, and D70745-40x is the board inside it. You're good here because D70745-404 is with -005 version of I/O fan module.
So the chassis firmware = cmm firmware ?
Anyway, on the firmware page I can not see a listing for the CMM
Also can not find anything like UFU ...
On top of the firmware I can see this
Current Build Version: 188.8.131.5211014.32243
Is this the chassis firmware ? Is this what we are looking for
just go to the web GUI of the CMM and run diagnostics - there you'll find the CMM version. Under Diagnostics -> Tests you'll get any informations about your hardware and software versions of the blade.
Firmware version 11.5 indicates that you might not have a MFSYS25 but a MFSYS25V2.