Hi scooter - All the other owners of the DZ77BH board are commiserating about BIOS updates or lack of them. I just took a quick read of the Tech Spec for your board which you can find here http://downloadmirror.intel.com/20955/eng/dz77bh-55k_TechProdSpec02.pdf. To get started, I recommend you use the two blue sata 6Gb/s ports and the three black sata 3 Gb/s ports. The blue for your Samsung and the black for your other HDs and optical. You will find the blue port is also backward compatible for earlier sata interfaces. All these ports are via Intel's Z77 chip and will support RST (RAID) if you opt for that. The gray ports are via a Marvel controller and I am not familiar with it. Good luck. Peter
Thanks so much for the very helpful answer. All is up and running just fine. EeeGads, this SSD boots in 15 seconds. Freaky fast......
Hi, just a short feedback on that - maybe helpfull if some one has the same problem.
Drives: 2x SSD SATA 3 - 1x HDD SATA 3 and 1x DVD SATA
Controller Set to AHCI.
Using all this devices on the Intel controller didn´t work! All drives are shown in the Bios, but it wasn´t possible to boot from the DVD. So I have installed Win 7 from an USB device.
What happens with Win 7: SSDs correct, DVD was shown and detected, but doesn´t work! HDD wasn´t found at Devicemanager and administration. Driveletters in the administration looking strange. (1st SSD C: - fine, 2nd SSD F:, DVD D:)
However here is the Solution for my config.
SATA on AHCI Mode - clear
Both SSDs on SATA 3 - the blue connectors
DVD on SATA 2 (black ones) - NOT at the single one!!!!
HDD on the grey connectors (Marvell Controller)