2 Replies Latest reply on May 10, 2012 2:16 AM by merlinios

    Problem with Raid5 setup




      I have intel server SR1690WB with server board S5500WB. I have purchased intel software raid key and i have enable raid5 .


      I create RAID 5  aray with 4 hard disks of 3TB each. I then create 2 virtual disks . The first is 40gb and the second is the free space that left from the array. I intalled windows 2008 r2 in the 40gb virtual disk but i cannot boot from this virtual disk. In bios in boot sequence i only see that i can boot from onboard raid controller ( AHCI) and not software raid i have allready setup .


      Any help? I have installed latest bios .