0 Replies Latest reply on Feb 28, 2012 10:10 AM by Scarecrow57

    R520 SR2 Fiber in Promiscuous mode


      I have an Intel X520 SR2 that is connected to an aggregator tap.  This device will be used to montior traffic on the link.


      The problem is I get the following message when starting the network:


      failed to load because an unsupported SFP+ module type was detected.


      However, when looking at the card the link light is on and the activity light is blinking.


      So the questions:  How does the card determine if there is a link?  That is does it look to be able to send a signal as well as receive?

      What settings are needed to make the card work in this mode?