The only question I really have is assembling the board and thermal solution in the case. It's not really intuitive (at least not to me).
Thanks in advance for any help.
I am working on this combo. But there was a problem to power on the system.
You need to remove the plate from the heatsink and put on the back of the MB.
Then you can mount the heat contact with heat pipe on the top of MB.
At first mount the heat sink then put them into the case.
Look at the manual you can know what I said.
In-Win K1 also missed a power switch pad inside the case in the system. So I can not push the power button to turn on when I seal the case. I can pull the cover of the case a little bit then the switch tip can touch the button.