I just upgraded my motherboard to a DX58SO2 and can't access the raid configuration utility.
I have two hard drives in Raid 0, which worked fine on the previous motherboard.
Currently during boot, it states both hard drives are non raid disks. And prompts to press ctrl-1 to enter configuration utility. This screen lasts about 0.2 seconds and any attempt to press ctrl-1 is useless.
Any ideas on how am I supposed to access this?
Be holding down or repeatedly pressing CTRL+I around the time that message comes up. It may take a few goes but you should be able to get in there. If your board has a fastboot option in the BIOS, try turning that off to see if it gives you more time.