0 Replies Latest reply on Dec 2, 2008 10:20 AM by

    certificate problems with scs

      I'm having a problem setting up scs to do remote configuration for Dell 755s. I have a godaddy certificate for the default website. Do I also need to set up the certificate authority for tls? When I run activator on one of the 755s I get the following message:

       

      Step Into: CheckAMT
      Connected to HECI driver, version: 3.0.30.1086

      BIOS Version:   A11


      Intel AMT code versions:
      Flash:                   3.2.1
      Netstack:                3.2.1
      AMTApps:                 3.2.1
      AMT:                     3.2.1
      Sku:                     12
      VendorID:                8086
      Build Number:            1022
      Recovery Version:        3.2.1
      Recovery Build Num:      1022
      Legacy Mode:             False


      Setup and Configuration:     
      In process

      Setup and Configuration TLS Mode:
      PKI
      Step Into: CheckPKIPPSPIDStatus
      Connected to HECI driver, version: 3.0.30.1086
      Step out: CheckPKIPPSPIDStatus error 0
      Step Into: CSCSER::PerformSCSRemoteConfiguration
      Step Into: CSCSER::SCSSetAMTIdentity
      Step Into: CSCSER::SCSCreateOTP
      AMT version: 3.2 Step Into: StartConfiguration

      BIOS Version:   A11


      Intel AMT code versions:
      Flash:                   3.2.1
      Netstack:                3.2.1
      AMTApps:                 3.2.1
      AMT:                     3.2.1
      Sku:                     12
      VendorID:                8086
      Build Number:            1022
      Recovery Version:        3.2.1
      Recovery Build Num:      1022
      Legacy Mode:             False


      Setup and Configuration:     
      In process

      Intel AMT Mode:      
      Non Legacy

      Remote Configuration:  
      enabled

      Setup and Configuration TLS Mode:
      PKI

      RNG seed status:
      exists

      PT_STATUS_INVALID_PT_MODE: Command is not permitted in current operating mode.
      Activate Intel AMT configuration:
      failure
      PT_STATUS_INVALID_PT_MODE: Command is not permitted in current operating mode.Step Into: StartConfiguration
      Step out: StartConfiguration error 3
      After StartConfiguration 3
      Exit with code 2
      Platform is already in setup and configuration mode.
        This may be due to 'bare metal' setup or because the utility was already run.
        This error can be ignored if the utility was executed to send the FQDN
        to the SCS without opening the Intel AMT network interface

       

      What do I need to do to make this work?

       

      Thanks