2 Replies Latest reply on Sep 4, 2011 7:58 AM by billprus

    S5000PSL will not browse with static IP.

    billprus

      S5000PSL will browse internet and network if ipaddress is set dynamic.  Will not browse and networks very slow if set to static ip. Anti-virus installl brings system to stand still. Tried 2 physical network locations with differing routerrs etc.. Set DNS to router IP and to actual ISP DNS addresses. Netmask set to 255.255.255.0   Hardware diags pass. Installed new hard drive and fresh server 2003 std ed r2  same issue. Has anyone seen this before ? Is this a setting somewhere on this motherboard, or a motherboard failure ?  FYI: Onset of issue was Microsoft asking for re-activation of O.S. with no hardware changes having taken place.

        • 1. Re: S5000PSL will not browse with static IP.
          Doc_SilverCreek

          When you set it to dynamic, who is serving your IP address?  (router or ISP)

          Are you connecting one or both NIC's to the router?

           

          A basic set up for a static IP on you mother board should look like this:

          IP address = 192.168.1.10

          Sub net mask 255.255.255.0

          Default Gateway = 192.168.1.1 (router)

          Your router should have an local IP of 192.168.1.1 and a dynamic IP of what ever your ISP is providing. (168.134.92.111)

           

          If you want to connect both NIC's or team the NICs it is a little more complicated,

          Connecting both NIC's wit out teaming them can create an ARP loop and tank you network.

          • 2. Re: S5000PSL will not browse with static IP.
            billprus

            When you set it to dynamic, who is serving your IP address?  (router or ISP)

            Ans. router

            Using a netgear  which connects to at&t adsl modem. Workinng fine on other computers.

             

            Are you connecting one or both NIC's to the router?

            Ans. 1 nic

             

            A basic set up for a static IP on you mother board should look like this:

            IP address = 192.168.1.10

            Sub net mask 255.255.255.0

            Default Gateway = 192.168.1.1 (router)

            Your router should have an local IP of 192.168.1.1 and a dynamic IP of what ever your ISP is providing. (168.134.92.111)

            Ans.

            IP address = 10.0.0.100

            Sub net mask 255.255.255.0

            Default Gateway = 10.0.0.1 (router)

            dns 10.0.0.1

            ISP provides 2  dns which I have also tried to manually key in as a possibe fix.  Have also tried moving system to a Comcast site with same results

            no other systems using IP 100

            Both locations will work dynamic to internet but not as static. It does talk across network to other computers but very slow at both locations.   And I did set IE locations settings to auto detect,

             

            If you want to connect both NIC's or team the NICs it is a little more complicated,

            Connecting both NIC's wit out teaming them can create an ARP loop and tank you network.

            Ans.  Only using one Nic.  Other nic set to disabled